收藏本站
LTC3212
OPERATION
R SETG =
R SETB =
R SETR =
I LEDR =
AnovercurrentshutdownmodeontheI SET pinswillpre-
vent damage to the part and the LED by shutting down
the LED drivers. Choosing an R SET value of 5.9k or greater
will ensure that the part stays out of this mode. When in
normal operating mode current, regulation is achieved by
controlling an active current source.
In shutdown mode all internal circuitry is turned off and
the LTC3212 draws very little current from the V IN supply.
The LTC3212 enters shutdown mode after the LEDEN pin
is brought low for 350μs.
Short-Circuit Protection
When LEDEN is brought high, the part will connect V IN
to CPO through a weak pull-up until CPO has charged to
near V IN . After the LTC3212 detects that the CPO voltage
is near the V IN voltage, it then enables 1x mode. If the
CPO is shorted or falls below approximately 1V, then the
LTC3212 is disabled. After falling below 1V the LTC3212
will use the weak pull-up to charge CPO to near V IN before
re-enabling the chip.
Soft-Start
To prevent excessive inrush during start-up and mode
switching, the LTC3212 employs built-in soft-start circuitry.
Soft-start is achieved by increasing the current available
to the CPO capacitor over a period of approximately
100μs.
Charge Pump Strength
R OL is dependent on a number of factors including the
oscillator frequency, flying capacitor values and switch
resistances. From Figure 1 we can see that the maximum
output current in 2x mode is proportional to:
2V IN – CPO
R OL
LED Current Programming
The LTC3212 includes three accurate, programmable cur-
rent sources that are capable of driving LED currents up
to 25mA continuously. The current is programmed using
an external resistor for each channel. The equation for
each external resistance is:
177 . 6
I LEDG
177 . 6
I LEDB
177.6
I LEDR
Alternatively, if either the I SETR or I SETB pins are connected
to V IN , the respective LEDR and/or LEDB current will au-
tomatically use the R SETG resistor and be set to:
177 . 6
R SETG
When the LTC3212 operates in 2x mode, the charge
pump can be modeled as a Thevenin equivalent circuit
to determine the amount of current available from the
effective input voltage and the effective open-loop output
resistance, R OL .
R OL
I LEDB =
+
177 . 6
R SETG
–
+
2V IN
CPO
–
3212 F01
Figure 1. CPO Equivalent Open-Loop
3212fb
 
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTC3214EDD#TRPBF IC LED DRIVR WHITE BCKLGT 10-DFN
LTC3215EDD#PBF IC LED DRIVR WHITE BCKLGT 10-DFN
LTC3217EUD#TRPBF IC LED DRVR FLASH TORCH 16QFN
LTC3218EDDB#TRPBF IC LED DRVR FLASH TORCH 10DFN
LTC3219EUD#PBF IC LED DRIVR QVGA DISPLAY 20-QFN
LTC3220EPF#PBF IC LED DRVR QVGA DISPLAY 28UTQFN
LTC3230EUD#PBF IC LED DRIVR WHITE BCKLGT 20-QFN
LTC3452EUF#TRPBF IC LED DRIVER PHOTO FLASH 20-QFN
相关代理商/技术参数
LTC3212EDDB-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:RGB LED Driver and Charge Pump
LTC3212EDDB-TR 制造商:LINER 制造商全称:Linear Technology 功能描述:RGB LED Driver and Charge Pump
LTC3214 制造商:LINER 制造商全称:Linear Technology 功能描述:500mA Camera LED Charge Pump
LTC3214EDD 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3214EDD#PBF 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3214EDD#TR 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:否 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3214EDD#TRPBF 功能描述:IC LED DRIVR WHITE BCKLGT 10-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3215 制造商:LINER 制造商全称:Linear Technology 功能描述:700mA Low Noise High Current LED Charge Pump